Re: IF output range of AD 8342

Dear Benjamin ,

   Thanks for the reply .

My requirement was actually to convert the balanced output of AD 8342 to single output which would be fed later to a filter ,, however the transformer TC1-2T as mentioned in datasheet only supports IF in range 300MHz to 3GHz while my required range is is say around 50 to 200 KHz.

Please advice as to what can be done the company replied saying :

" transformer or balun usually don’t have good performance at such low band. You may consider using amplifier to convert between single-ended and differential signals or consult with transformer/balun vendors for part-selection."

Please advice for converting differential o/p into single o/p.

Thanks